To avoid these ads, REGISTER NOW!

The Salvage Shop

To avoid these ads, REGISTER NOW!
OP
T

thomascreation

Well-known member
Joined
Jul 21, 2010
Messages
90
Location
Peoria IL
Electrician ran into a schedule problem, he should be done in the morning. I took a detour from the shop to make some repairs on the roof. Eventually I'll need to tear off and re roof the tall section of the building (about 1k sqft) but for the time being I'm going to limp it along. There was trickle of water getting in at the parapet wall. Someone in the past attempted to smear tar over the slits in the membrane but didn't succeed. I scraped the entire 50' wall of loose material, tared, added mesh and tared again. Should be good for a while. Also took in the view!
 

Attachments

  • KIMG0640.jpg
    KIMG0640.jpg
    127.5 KB · Views: 125
  • KIMG0638.jpg
    KIMG0638.jpg
    149.5 KB · Views: 130
  • KIMG0637.jpg
    KIMG0637.jpg
    148.9 KB · Views: 136
Last edited:
OP
T

thomascreation

Well-known member
Joined
Jul 21, 2010
Messages
90
Location
Peoria IL
Well I have power! electrician is done with the 100 amp sub panel. He installed 3 20amp circuits for outlets along the wall, wired in the 220 heater and installed a disconnect box on the other side of the wall for my air compressor. Paint is on the walls and I built a pretty darn sturdy work bench as well. Time to start moving tools in.
 

Attachments

  • KIMG0660.jpg
    KIMG0660.jpg
    136.6 KB · Views: 88
  • KIMG0657.jpg
    KIMG0657.jpg
    137.5 KB · Views: 88
  • KIMG0648.jpg
    KIMG0648.jpg
    138.4 KB · Views: 81
To avoid these ads, REGISTER NOW!
OP
T

thomascreation

Well-known member
Joined
Jul 21, 2010
Messages
90
Location
Peoria IL
Moved some tools into the shop and plumbed the air line under the electrical conduit. The compressor is going on the other side of the wall but I still need to hook it in.
 

Attachments

  • KIMG0704.jpg
    KIMG0704.jpg
    131.9 KB · Views: 57
  • KIMG0706.jpg
    KIMG0706.jpg
    136.2 KB · Views: 55
OP
T

thomascreation

Well-known member
Joined
Jul 21, 2010
Messages
90
Location
Peoria IL
Time for a quick update. This is the shop as of today. Finally got the Honda over to its new home. In case anyone is wondering, the car is a Honda S2000 with a Ls1/6spd swap.
 

Attachments

  • KIMG0990.jpg
    KIMG0990.jpg
    133.5 KB · Views: 63
  • KIMG0992.jpg
    KIMG0992.jpg
    139.4 KB · Views: 60
  • KIMG0995.jpg
    KIMG0995.jpg
    138.5 KB · Views: 59
  • KIMG0997.jpg
    KIMG0997.jpg
    142.4 KB · Views: 54
To avoid these ads, REGISTER NOW!
Top Bottom