baugh009
Member
Anyone have/used Makita impact sockets? I didn't know that they made any.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Makita Impact Sockets
- Thread starter baugh009
- Start date
Anyone have/used Makita impact sockets? I didn't know that they made any.
I have used them with a cordless impact driver and also with a ratchet. I have not had any issues, and have not used them much. I did like the little wobble extension it came with.
These get used as a grab and go set, they not used a primary impact set. I think they would do ok if not abused, they seem decent for the cost. I would still be cautious for the eyes though.
gdocktor3
Well-known member
I have seen them in store, but never used them. I do have the impact bit set with the nut drivers and they have held up really well. I just looked on Amazon and Home Depot website and there are no reviews under 4 stars.
Richard Cranium
Well-known member
Didn't even know they made impact sockets or I wonder who makes them for them.
cptn_zippy
Well-known member
I have the SAE set and have pounded on them. They're fine. I think they just released the metric ones. I'd buy them but got the williams/colbalt set from Cripe.
J
J