Garage door install

[Hivolts]

What are you paying for 2 single door installs with all new hardware and torsion bar. Mine are 8 by 7. Quote was for non insulated, no window, steel. Quote was $2300. Good or bad?

 

[Hivolts]

Oh yea, no openers included. Both are still good to go. Thanks

 

[gnpenning]

It depends on your location. I would love to get that much for 8x7 PAN doors less openers.

 

[upndown]

Way overpriced in my books!

 

[kd3pc]

under $1K for hermann, insulated, installed in new construction, with openers and two remotes.

 

[Hivolts]

Charleston SC area.

 

[Hivolts]

Under $1000 for hardware? Or is labor included in that 1K? Just a decent opener is $150 times 2

under $1K for hermann, insulated, installed in new construction, with openers and two remotes.

 

[matt_i]

I got a Haas kit, 9'w x 8' tall, stock color, including every piece of hardware, 2" thick full foam insulation, no windows, no opener, $650, I pick up at the local dealer's shop. They also never came out to measure, I had 1/16" dimensions of the rough opening when I went there, i did take pains when framing to build to the 108" x 96" within 1/16". I took pieces of my new vinyl siding into the shop when selecting the color for an accurate comparison.

The one thing I did differently was not to use the hex head 1-1/2" long screws that came with the kit to mount the track. I used GRK-RSS washer-head screws which are 3" or 4" long depending on the location they were in.

I did wind the spring the wrong direction when assembling it, that caused some weird behavior. But then I studied my other doors and realized the error. No harm done.

 

[upndown]

Springs installed backwards happens more than most guys will admit. Easily done, just remember right wound spring goes on left side of center bearing and vice versa. No damage done.

 

[Blazinzuk]

2 12x12 fully insulated steel backing doors no openers 1200 each + 200 each for install

 

[Falcon67]

FWIW, having done a couple of doors I wouldn't pay anyone to do an install. Last one was a 16x7 done single hand. I used an 8x7 in the old shop and I think it took maybe 4 hours total from package open to roll up. Less than $300 total cost.

 

[Firebird 1]

With an opener I would charge no more than 700 for that set up per door. I get 550 for just the door installed. Guess it depends on where you live.