crazybrit
Well-known member
There was a recent thread here but it was mostly focused on ways of capping tubes.
I have a few tubes of fairly expensive adhesive products ($15-20 tubes). Everything from 1K fillers to high temp PCB epoxy.
It's annoying to have to pay $15 and find the tube has dried up and also it stalls the project.
I bought a set of these off AliExpress. They work well the first time. Once opened they don't seal well subsequent times. I'd always wrap with a cloth before sealing so no sharp edges but I'd find they would leak at the valve on subsequent sealing attempts.
Curious if anyone has suggestions for something similar but more durable. Good for at least 10 seal, open, seal cycles.
I have a few tubes of fairly expensive adhesive products ($15-20 tubes). Everything from 1K fillers to high temp PCB epoxy.
It's annoying to have to pay $15 and find the tube has dried up and also it stalls the project.
I bought a set of these off AliExpress. They work well the first time. Once opened they don't seal well subsequent times. I'd always wrap with a cloth before sealing so no sharp edges but I'd find they would leak at the valve on subsequent sealing attempts.
Curious if anyone has suggestions for something similar but more durable. Good for at least 10 seal, open, seal cycles.