Recent content by 10GT500
-
1
MaxJax Transport, Install, Impression, and Comparison
well finally got it up and running.. the wej-it anchors actually worked out great, that was one of my fears that it wouldn't set in properly or "lock" in the hole. [/IMG] [/IMG] [/IMG]- 10GT500
- Post #548
- Forum: General Garage Discussion
-
1
MaxJax Transport, Install, Impression, and Comparison
yes I've seen the epoxy type are the most popular to use but a little messy... :thumbup:- 10GT500
- Post #543
- Forum: General Garage Discussion
-
1
MaxJax Transport, Install, Impression, and Comparison
bought mine last December from home depot and just now after finally getting my slabs done. My floor was only 3 to 4 inches thick so i did a 3x3 hole and one and half foot deep footings... now I'm ready to drill for the anchors but a bit worried as to most people saying some wont set in or lock...- 10GT500
- Post #541
- Forum: General Garage Discussion
-
1
Maxjax Installs: Post Here
I'm planning on fabricating a set of mounting plates also only because I like it better than the wedge inserts.. now can I just use regular quikrete cement mix from the bag or would a stronger type concrete still be needed?- 10GT500
- Post #1,178
- Forum: General Garage Discussion
-
1
Hi from Mass
Been lurking for some time now doing research on my max jax lift install. . Lots of good info in here and glad to be a member!- 10GT500
- Thread
- Replies: 5
- Forum: Introduce yourself here!