1930artdeco's latest activity
-
11930artdeco replied to the thread New Weaver WA-72.If you look at the first close up shot you see what looks like a socket end. Well it is. It is a 3/4" extension that was cut down. Now I...
-
11930artdeco replied to the thread New Weaver WA-72.Well ordered a rebuild kit for the jack plus an extra gasket to go under the high pressure system bolt thingy. Just on a hunch, since...
-
11930artdeco replied to the thread Vintage air compressor ID.Looks like a speed air to me.
-
1what is the best way to keep a jack rebuild kit with rubber and leather pieces preserved? I know away from UV light but what about temps...
-
11930artdeco replied to the thread New Weaver WA-72.Well, filled her up, lifted the truck up about three inches and held for about 5 minutes and then blew a seal😢🤬. Rebuild time…
-
11930artdeco replied to the thread New Weaver WA-72.Ok, finally picked the jack up and got it home. Here are some pics of it. I don’t understand why they put a 1/2” drive adapter there at...
-
-
11930artdeco replied to the thread Recent vintage Craftsman Lathe purchase ....Dang, I think you did very, very, well for that price. I would have bought it and I don't need or know how to use one. Mike
-
11930artdeco replied to the thread Sun Electric Engine Tester.You can try paramount dist. he MAY have something or know where to get one. Mike
-
11930artdeco replied to the thread Vintage Floor Jack Identification Help Needed..2Ton, Weaver, I have the same one from the 70's. Well I have it but it is still at my friends house. Mike
-
11930artdeco replied to the thread New Weaver WA-72.Shelbylex, I have been following your Titanic jack thread. The only issue I can see (after about 1 minute of looking it over) is that it...
-
11930artdeco replied to the thread Please check my math on Jack limits.My jack stands are the stamped steel kind but they are old-as in made in Los Angeles, U.S.A. or just plain USA. Not sure about the cast...
-
1Going to pick this up from a coworker sometime soon. Well when work slows down. Apparently it is a 2 ton weaver floor jack. Jacks up and...
-
-
11930artdeco replied to the thread Confirm this Allan lathe is for valves please.Cool thanks. I told him it might have been for armatures but he didn't remember his dad using it for that. Then we thought it was for...
-
11930artdeco replied to the thread Please check my math on Jack limits.Always!!!!! Good to know I can still add-more or less.
-
1I just got a Weaver WA-72 floor jack rated at 2 tons. I am going to use it to jack up my 88 F150 at some point to change shocks, brakes...
