Recent content by 1badrz28

I purchase a Hot dawg 60k from Shurail heating in Bloomington, MN. They were the cheapest I found around, even online. Than went to Menards for the venting which was around 100.00 or so for the b vent. I ran the copper line before the sheet rock was put up in my new home, but my old home I ran...

https://www.amazon.com/Vent-unwanted-Humidity-Contaminants-Ventilation/dp/B07L2F8V6C/ref=sr_1_4?crid=2Z3ZAHT6MFHMI&keywords=garage+ventilation+fan&qid=1578946115&sprefix=garage+vent%2Caps%2C161&sr=8-4

Just built a home with an attached 1000sf garage and ever since winter hit, I had high humidity problems in my garage. The insulated garage doors had so much condensation that they were freezing shut. I researched a lot on here and other online resources and came to the conclusion that I needed...

3/8 is fine., I have blown out all of my irrigation systems with up to 15 zones with a 3/8 hose. A compressor with a good rate of cfm will keep up no problem.

As long as the electric and hydraulic lines are protected, you should be fine.

increasing my post

Installed picture

Hi, First off, thanks to all who post here, as I spent a lot of time reading about other people's garage humidity problems. I had a new build 1000sf attached garage finished in early Sept. I wasn't really monitoring the garage humidity in the fall, but as the temperature hit the single...

That's where I bought my 60k Hot Dawk for 692.00 picked up. I probably have 150.00 in 3 inch piping, fittings, and regulator. If you have gas and electric nearby the mounting location you'll have less than 1k into it. Otherwise, the price will escalate by installing electric and gas. I had a...