Recent content by 2000xpsd

And you are correct 1 3/8"...found that on the Dannmar ones, which is bendpak

****, I'm at 1.5"

Can someone with a xpr measure their arm pad bore. I have a rotary and want to buy frame cradles but the rotary ones are ridiculous...$300+...the bendpaks are half that. I think they are the same but wanted to make sure, couldn't find and specs online

Yeah that door is for storage plus there is a car port on that side...plus it faces north so there isn't much light coming in... so it doesn't really matter, treat it like a wall I figured. Getting close to finished now but I'll get some more pics up later...here's another crappie of the front...

Just wanted to send a thanks out to Platonic Solid for help with my light design. What difference it is between slapping some fixtures up and hoping it's right and having someone who knows what they are doing plan it out. The lighting in my garage is very bright but more importantly it's easy on...

Getting ready to buy a lift, was going to get a xpr10 but was also looking at Forward...does anyone know what the diff is between the dp10a and the i10? The i10 says heavy duty and the dp10 says light duty...but yet they are pretty much the same price. Curious if anyone knows what the deal is...

According to other posts (1) 12/2 is ok...I forget the percentage it comes out to

Found a couple of threads on this but no clear answer... I'm wiring my flouresant lights in, they are connected with 1/2" metal conduit, can I run 12/2 to connect them all or does it have to be thhn? I know you can't when it in a wet location but this is indoors so I need a code expert. I've...

Cool, thanks for the links. I'll keep searching too and see what's out there.

I ordered the fixtures, however I'm having trouble locating those FO32/850/XP/ECO bulbs cheap...or even reasonable. Any lead on those or an alternate bulb that is good and throws the same or better amount of light? ...I've been searching for hours, there are so many bulbs out there and prices...

Platonic It's been a few months but I got a little side tracked in my garage project but I'm all caught up and back on track...I'm ready to order these fixtures and bulbs asap. But before I do I know how fixture and bulbs prices and sometimes even better ones pop up...my question is should I...

I have 2 nests 2nd gen in the house and that same hwell in the garage. Hwell was only $100 bucks so that made more sense for the shop instead of a $250 stat. Only complaint is that it doesn't log run times like the nest which I really wish it did so I could track gas usage. So if I did it again...

You might want to have a 425 meter put on...if it already isn't, I doubt it is tho. Should be free to do so. 1" line will be ok I ran off the meter 260' of 1.25". Before the meter the psi is very high but the reg is set @8"wc. At my heater in the garage I have 7.5"wc. I've ran the heater full...

Charts might of had different inlet pressures. If your coming off after the reg it's probably 8"wc. Check out gastite's chart, it's pretty good https://www.gastite.com/downloads/pdfs/peinstallationguide_1.pdf

32x48 R38 ceiling R20'ish walls...2x6 open cell R13 doors 2"xps 4' down on outside and inside of foundation 1"xps under 4" floor Heating with NG radiant closed loop system. About 30,000btu but that varies with the delta t I also stubbed a extra gas line in the ceiling in case I needed to put...