Recent content by 2001ZR2

On Friday found the source of the air leak on passenger door on my 5 spd Blazer...the latch needs adjustment. Tried several hammers to "adjust" the sticker plate...of course the biggest one was the correct choice. BTW down pours of 1-2 inches per hour are great for finding leaks. Fixed it...

One thing that is out of sight so out of mind was the outer walls were uninsulated...the side I replaced the board and batten with Hardy board is insulated. This is the biggest outside wall and made a bug difference. Been following this thread and others mentioned this.

Electrical upgrade to the Garage. Have 4 outlets with two 20 amp circuits. Added outlets to hang vastly improved lighting i.e. I have the ability to practice for the rapture if I look up. No more re setting the GFCI on the only 15 amp circuit for lights and 2 outlets

Today was pull tools out of the garage to work. Cleaned the cotton wood seeds off of the a/c unit. But also cleared where the unit had been covered in mud. Now the bottom inch about half way around works again. Noticed a hose splice was leaking so adjusted it and tightened the clamp. The...

Order 35580 but discount didn't go thru...I'll call Monday. Thank you to Jori and GJ for this event.

Wednesday mower pit stop prior to mowing This pulled apart the spray nozzle on my pump sprayer twice and cleaned it. Poison Ivy uses chemical weapons so I felt the need to do the same. Sprayed the yard before it got hot. The front storm door received 2 replacement screws for middle hinge...

That pry bar was believed to have been appropriated by one of my sons or left at pick n pull. Found in a plant bed next to my driveway. Spent some time cleaning it up today...pitted pretty bad so not going to ever be perfect but it will be a usable tool again

I also bit on that one and I might need a support group with bad coffee.

. Took advantage of a Klien deal at Lowes probably use it for bit then use a car set for minor fixes i.e. annoying rattles on road trips .

We use it to verify higher alloys as Stainless steel is not got in low pH service but Hastelloy is some cases.

No chrome or cadmium showed up when I shot the 3/4" with PMI. Just Fe, Mn,S,Si closest material carbon steel. Plain steel?

I may have triggered the apocalypse...at least in a GJ sense. I wanted spray weeds around my house and.... 1. I knew where the sprayer and chemicals should be in my garage. 2. They items were where I thought and the bottles had sufficient levels for spraying tonight 3. The sprayer pumped up and...

Might be the misfire on my.wifes truck...damn AFM bull**** that GM used. Might be time to look into the delete cam package.

Yesterday I finally installed buffing wheels on my buffer and tried it out. Part of getting a set of SAE sockets ready to send to my son.

Quick run thru the ultrasonic cleaner with Evaporust then a hand polish with Maas. Going call it good enough to fight the Third Reich.