Recent content by 2005UltraClassic

The system air bleed is located above the flanged ball valve. To operate it, one opens the thumb screw at the top to relieve the air, if any, collected inside the valve. Then re-snug the thumb screw. A float inside the valve keeps the system fluid from leaving the system. Visit our the...

Heater temperature at max (factory set) is 120 degrees F., well within the range that can be used with this material. PEX loops in concrete are 1/2" X 300'. Separate kit sold by the each. 300 Fool Loop Kit. Plan for 1 linear foot per square foot of concrete slab.

Thanks got that fixed.

Greetings from Minnesota. I am the National Sales Manager for Radiant Made Simple, a single zone in-floor radiant heating system that is sold as a kit for the DIY individual. We are an Alliance member. Please check us out by selecting Terra-Therm, Inc. in the listing of The Alliance. With...

I don't think your short. What you have installed will work just fine. Otherwise, if it were me, I would install 4 rolls of 1/2" X 300 PEX. I would divide the area to install the PEX into 4 equal sections. I would install the PEX keeping each loop length at 300 feet. If you need help to see...

I recommend that you install, 3 each loops at 1/2" X 300'. Your spacing will be at 10". This will work out to be very close to 300 ' per loop ( actually 305 feet per loop, but you can fudge that amount with no problems). Because you have 3 loops, you will need a 3 port manifold. Radiant...

Sure could use some help to explain why I can not view my posts. Looked for help in previous posts and did not see anything. WOW guess the magic numbe is 3?

Not sure how far you have gone into your research, nor where you are located. You might plan a visit to this site: http://www.tthermgeo.com/geothermal.php

Greetings from Minnesota. Can hardly wait for Spring