Recent content by 2fst4u_7

What’s your thought on mounting height? My first thought was somewhere around 14’?

And the 125,000 is only input, output is 100,000. In assume most btu calculators are assuming output btu.

That is good to know. Our cold is in 0-20 range and only a short time usually. There is 2 12x14 r10 garage doors that are sealed up pretty well but I will keep an eye on it. I forgot to mention there will a wood stove in the corner for weekends and extended projects.

R21 walls, ceiling will be between r38-r49. Concrete is not insulated.

Just dried in my 40x80x16’ shop and was hoping to get some feedback on heater sizing. I purchased a 125k Mr Heater and every calculator I have looked shows it will be big enough but I am skeptical. Any feedback would be appreciated! Thanks

Thank you sir!

Just framed up a 40x80x16' pole barn and trying to figure out how big of a propane unit heater I should put in. Walls will be r21 and ceiling will be blow in with as much as I can throw up there. I found a few BTU calculators online that range from 60-110k BTU as a recommendation. That just...

Awesome! Thanks so much the help, so would you recommend this over the previous mentioned light from prolighting?

:bounce: That would be me haha! Thanks for the help anyways, guess Ill try the fixtures in post one and see what happens!

The distance between the rows is ~12ft. The spacing between the lights in the row is ~8ft. The purpose is hobby shop, hang out space. Walls will be taped, textured, and paintd white.

I already have the boxes installed, 10 total @ 2 rows of 5. Any suggestion for that setup?

I am sure this has been covered but I cant seem to find it... Can the LSS2XT8USE4803 be wired/ mounted end to end? My goal was to mount 10 of these in tandem, so 8' of light for a 36x48' shop with 14.5' ceiling. Am I going in the right direction?

How did it hold after the insulation was blown in? I assume you applied after the fabric was stapled up?

What type of glue should I use to adhere the insulation fabric to the stud face before blowing in the wall insulation?

For the first 4' of siding I put up metal. Initially I ordered brown but my wife liked the red so we went with that. Glad we did I like how it turned out. For the 12'x12' doors I went with a Wayne Dalton 8300, so approximately r13 value with the Liftmaster 3800's The Mrs painting the...