Recent content by 4advtr

I'll have photos up soon. I'm selling my lightly used BendPak HD9 4 Post Lift. Everything works perfectly, really only used it for oil changes and leaks on vehicles. Thus the wife has deemed I no longer need it (I'm OK with it as well). It's currently setup and fully operational. The new...

I have a similar situation, the easiest way for me was to use the below and add a second wireless router. Super simple to setup and works great. My speeds are fast enough to stream movies still so I'm content. http://www.amazon.com/gp/product/B004DVEW8I/?tag=atomicindus08-20 You'll want to...

I have the same lift and love it. I would assume that at one time it would go all the way down? Or is this the first time you've noticed it's not going down all the way and can't verify that it ever has? If the latter try loosening the cables as the previous poster mentioned.

Are there any Lowe's in Oregon, specifically Bend or Redmond that might carry this?

In thinking about this a little more I think 6 mil plastic would work if I can find it in white. It would act as a vapor barrier and have reflective properties as well. I really don't need all the benefits that FSK paper has to offer, it can get spendy real fast when covering a large are like...

Not looking to seal it up too tight, just doesn't make sense for me financially. In the end it's still just a shop.

I am about to finally start insulating the walls of my shop. There currently is no vapor barrier and likely won't be as it's basically a converted pole barn. I am considering using FSK paper above 8' as I'll have OSB on the bottom 8' all the way around. I will be painting the OSB white to help...

I am about to finally start insulating the walls of my shop. There currently is no vapor barrier and likely won't be as it's basically a converted pole barn. I am considering using FSK paper above 8' as I'll have OSB on the bottom 8' all the way around. I will be painting the OSB white to...

I have a standard metal roof pole barn with wood siding on the sides. I am in the process of bringing this "enclosed barn" into a full blown shop with insulation, lift, etc. It's roughly 38' x 52' with a 20' ceiling at its peak. I live in Bend, OR where we rarely see tons of the wet (mostly...

I'm in a similar situation, 32' x 53' with 14' walls and 20' center height. I'm framing it in right now for insulation, however it'll only be about R25 in the ceilings and R21 in the walls as I have to fit the insulation into 2x6 walls and ceiling girders. I'm planning on having a 100 Gal...