Recent content by 5window

Thanks for the replies. I just want to be able to warm it for a few hours now and then to work on the car. Like start warming at breakfast and work in the shop after lunch. I do have a propane patio heat and considered using that along with a CO monitor?

My garage-is 340 square feet with a 10' ceiling , with insulated walls and ceiling, concrete floor and leaky double doors. Currently, I've got a small wood stove but it takes too long to heat up and it's hard to control the temperature. So, I'm interested in alternative heating methods and...

I'm talking maybe 2.5 feet of pipe, air flow to tank/ air flow to hose, shut off to nozzle and tank pressure relief valves/ a cross to relieve clogs at the bottom and a couple of reducers/bushing. Rapid Air may be too complicated for my needs. Mostly I am concerned about pressure-heard about the...

I'm sorry to bring this up again, probably. I have one of those smaller HF media blasters I want/need to modify to help along with my airflow-basically 10.5 cu ft/min at 90 psi. I was planning to use 1/2" black/galv iron pipe and fittings (increased over the 3/8" rubber and pipe on the unit)...

Well, I have a built a couple, all different, but what I would like to share is a find I made when enclosing a bay in an existing 80x 38 5 bay machine shed. One bay was already enclosed and used as a workshop. The next bay over, I had a concrete floor poured then framed in the ceiling and two...

Thanks. There are two male threaded "fittings" on the left of the burner-one with the silver wheel, the other at the bottom of the black unit. Where does the supply line go?

I bought an oil fired mobile home heating unit for my new shop. I will be mounting it on an open pedestal to allow the heat to exit the bottom of the unit, and feeding it from a steel drum outside the shop, but still enclosed. I have no problem with the wiring/electrical supply but I am...

Okay, thanks for the tip= I'll check out some Studes-any idea what years?

I picked up a wrench at an antique store-double open end, some odd symbols on the back and stamped:"Tire Carrier Wrench". Actually, my wrench looks just like this one, but I only paid 50 cents. Any help id'ing it will be appreciated. Thanks...