Recent content by 63spyder

I coil all mine up and hang them on those old gun racks you use to see in old pickup trucks

I would like to play with one

Look for a saddle tee. It snaps on the pipe when glued then you drill down through the tap into the side of the pipe. Then glue your pipe like you would do a regular tee. I just used one on 11/4 line today. Easy peasy.

This is my decelermeter When it was important to know your deceleration

I bought a couple of the 5.0 Makita batteries on Amazon this last week that were on sale. I got them and put them on the charger,and they both registered as broken or bad. With a little research I determined they were copy’s. But really good copy’s. So good you would think with a little more...

I ordered a diy mr cool 12 k from Costco a couple of months ago and now just getting it installed. It came in three boxes, inside or cassette out side with the pump and a line set. Today I opened it all up and there was a line set boxed in with the outside unit. Both line sets are marked 25...

The kerf plate is considered a consumable, in other words just use it,, when it gets to bad replace.

I'll play. 14 inch Weston and Anderson bandsaw, 9 inch Wilton horizontal bandsaw, two Milwaukee hand held bandsaws,, 25 ton uni-hydro iron worker , a max 40 and miller spectrum plasma torchs, gas torch, 36 inch pexto stomp shear, 30 inch HF shear ,pexto rotary shear model 225- b. ...

I have two different buildings with two different brand of four foot leds, both buildings I can't play the fm stations. I tried running a temporary antenna outside to see if it made a difference, nope.. I'm going to run one up a tree further away to see if I can get a clear signal

Surprising how many proto wrenches I have once I got them all together. I also have a toyota wrench.

Length of hose doesn't matter ,same amount of fluid is pushed on both sides

I have three bench vices and two wood vises for wood working bench. The one ,504 1/2 ,has been in our home shop since I was 15, so for forty seven years it's been beat on abused and totally miss treated. It,s jaws are beaten smooth. I've pressed an unknown amount of u joints . And it still...

I run mine up and use it as a roll around work bench

I have a set of those I bought in the early 80 s. Also a set with the triangle grips instead of square

I use pex for air, works great. Did my whole house in copper, if I had it to do over I would of used pex with home runs.