67CarGuy's latest activity

Yup, that. Helps that I'm a stones throw from two regional airports at work or at home. @gpiggaz nailed it below. Don't buy a screen...

I saw this project in the Makerworld app and my wife is always using FlightAware to see where planes are going so I thought it would...

Maybe some cornasaurus?

Anyone in the area, we’ll have the 66 along with the speed boat at the Fathers Day car show at the Sully Historic Site, located at 3650...

Larry, you can bump a curve that size pretty easy. That is how I did the fenders for the rolling tool bench- 1/8" x4" flat bar. I just...

Had an insurance job in the shop, a collaboration with a local collision shop. One of those fancy, old-time looking hearse had a...

Still keeping busy here, but don't want to post the same old stuff as it gets boring. Last night however, I was toying with...

Should have the chrome plating going on this week... Saturday the truck participated in a poker run, I had invited a friend to ride...

A set of ball end hammers getting ready, these will be heading to Ohio. The shorty has a 2-1/2” radius on the face and a 7/8...

For clarity, he doesn’t know what he can’t do yet…

It's been a mile or so since Nebraska when the truck travelled from Oregon, July of 2024.. Friday evening... .....we were on...

It’s fine since we don’t know what we’re looking at most of the time either 🤔

I miscalculated the height of the interior. I was off by 5/16" The lid won't fully close. I'll print the top tray again, 3/8" shorter...

Not to say I've given up on the 3d printing... I was starting a project with the kids and my long rails used to hang on the garage...

You can easily add custom spacers attached to a Gridfinity baseplate — just use an online generator like this one...