Recent content by 6869704X4

It looked like he was trying to break it so he could make a video.

Left hand drill bits are your friend

Tractor valve stem? Edit: May require modification

When I was researching this I read an article where a guy just pulled the starting rope with the switch off. Claimed it built enough pressure and no worries of over pressure. I haven’t checked mine yet but think I’ll try that.

Wonder how this turned out. I had a wand stick on while using my pressure washer. Had to run over and shut it off.

Jack screw and ball nut I'm guessing. That's how the C-130 main gear goes up and down. Did some searching before I hit post. They use a nylon nut instead of a ball nut. They also have a clear floor model. Interesting. https://www.autopstenhoj.com/en/maestro-2-65-978.html

I'm gonna get me one of those. Kitchen sink drain gives us trouble now and then. My charming bride swears she doesn't let grease down it but I have my suspicions. I have a 4gpm hot water washer. All the hoses seem to be rated at 140F, 60C for you Canadians, so I would have to turn it down. Or...

I bought some Goodyear hose from Northern tool maybe a few years ago, not sure. It's held up very well. I just checked and they don't have it now. I wonder if the red Ironton brand is comparable.

I was drunk one night and ordered one, thought it cool. It works, air hose, water hose, I temp repaired a split hammer handle. That was two years ago. One beer induced purchase that wound up OK.

You didn't say what type or how much fluid you're moving. I put clear tube on a primer bulb, works for gas/diesel.

Build a room onto the other side of the house:)

Is that a welding cart your're using for a tire caddy? Good idea. I see you got some extra support for your lift too

This popped up on my FB after I read this thread. Sorry about the FB link put the one that I downloaded has an unsupported extension.https://www.facebook.com/share/v/JU5uBHQKXK5tPRVH/

Where'd you get them? I got some gaps too.