Recent content by 77broncodriver

I thought about doing that but it looks like the cable is not in a conduit. It looks like a SE type cable that is probably ran through the wall studs. Can I have exposed conduit on the side of the house above ground? I am thinking of punching a piece of conduit into the side of the stucco bump...

Here is what I am working with. I guess I can take up all the pavers and get close enough to get under there. Then I have to figure out how to get into the box from below as I assume there was a single conduit set in the concrete pad when the house was built. On the other side of the fence...

I will post a picture of where the main panel is located later today to show the dilema of running a new cable. Maybe you guys will think of a solution that I haven’t thought of yet. Sent from my iPhone using Tapatalk

I am going to look into how I can get a new 2ga cable into the main panel. Can I use a 100% continuous duty 90amp breaker to avoid only being able to use 80% of the power? If it is not worth bringing the 2ga cable to the main panel can I use a 50amp 100% continuous duty main breaker to get as...

I agree, from the beginning I wanted to put a 90-100amp panel but then ran into the issue of not being able to get the cable ran. Sent from my iPhone using Tapatalk

Thank you Landon. I am going to have to go back to the drawing board to see if there is anyway to run a new larger feed cable to the main panel without having to tear out the driveway.

I will have about 4 - 220v items (welder, air compressor, 2 post lift, table saw) which are all rated at 30amps or less. I do not think that I would have to run any of these at the same time, though it would be nice not having to remember to turn off the compressor when I go to use any of those...

Hey Guys, New to the forum here. Well Ive been reading for a few years but first time posting. We are building a 30' x 40' red iron detached garage on our property, just signed the papers and getting the permits set up now. While we are waiting for the building to show up I am going to...