Recent content by 77cj

Just built a 24x32 pole barn in Pa. Where can I purchase hd6600? Sent from my XT1060 using Tapatalk Edit: found their website. Thanks

Anyone know of a reasonably priced new motor? Sent from my XT1060 using Tapatalk

I'm looking for a new or used compressor duty motor for an older IR T30. Don't want to pay a lot due to it's a compressor for the barn. I already have a newer model IR in the garage. Sent from my XT1060 using Tapatalk

I did think of that possibility also cya, in your opinion do you feel that would be better or I went to Lowe's last night and they do have .250" thick steel 90's. I was thinking of bolting 3 90's to the top of each Superstrut drop using existing strut holes and bolting directly to the 2x8 bottom...

I did think of that possibility also cya, in your opinion do you feel that would be better or I went to Lowe's last night and they do have .250" thick steel 90's. I was thinking of bolting 3 90's to the top of each Superstrut drop using existing strut holes and bolting directly to the 2x8 bottom...

Thanks AK, I did see and was thinking about those as well. Sent from my XT1060 using Tapatalk

I am installing a 32' x 3' overhead shelf 3' down from the ceiling across the back of new pole barn. I was going to use 2x6's and frame a ledger board ancho red to posts. Use metal hangers on both front and rear framing runs to hang 3' 2x6's between. Obviously the rear wall will support the...

OK great, I thought I read someone stating an article in NEC saying that you couldn't do that anymore. Meaning protecting other receptacles through a "removable" receptacle. It was probably for a different wiring setup. Sorry pattenp, I know my terminology is in need of improvement. I...

I was thinking you could share the responsibility if a gfi by installing at the beginning of a circuit and running the common across the gfi to protect the rest of the circuit. Sent from my XT1060 using Tapatalk now Free

Alright I'm picking up where I left off last week. Getting ready to buy and run receptacles on 20 amp, 12 ga. circuit. In looking at probably 4-6 receptacles on a circuit and from reading on her it looks like you cannot run a common neutral on the first gfi? Will I want to run all gfi's in...

That's great information. I exchanged the service panel yesterday and picked up 2-8' grounding rods and #6 solid wire. Probably pick up the MHF cable tomorrow on lunch then you know where I'll be this weekend!! Sent from my XT1060 using Tapatalk now Free

Thanks, how about height of recepticals and switches? Sent from my XT1060 using Tapatalk now Free

OK, so what did we agree on from the last few posts? Romex on top or bottom of the 2x6 as viewed in pics would be OK or not? Sent from my XT1060 using Tapatalk now Free

If I'm going to use PVC conduit, would I want THHN stranded or solid? and would it need to be THHN-2? Sent from my XT1060 using Tapatalk now Free

Thanks, that is what I will do then. Sent from my XT1060 using Tapatalk now Free