Recent content by 88rxn/a

Thanks all. Good to see i dont need to spend a lot for a decent setup. Sent from my SM-G920V using Tapatalk

curious what manifolds everyone is using nowadays? this will be for a radiant heat (5 loop) garage setup. don't need anything fancy...

I see. Where does the extra cost come from? Is it from having to remove the shell to place the insulation between it and the frame? Is some sort of woven insulation still feasible after its built or does it have to be foam board? Thanks for the offer, i will pm you. Also, i have not pursued the...

Its not the price of labor + the insulation, its the amount of money i have available that makes it an absurd amount (to my wallet). I really wish i could have it done now and be done with, i just can't get another $8,500 right now. Sorry if i offended you (you seem irritated). Sent from my...

I still haven't decided on insulation yet... They wanted an absurd amount to install insulation. Id rather put it in myself and save the cash but.not sure what type to got with Sent from my SM-G920V using Tapatalk

im looking into options on what i can install before the pour. i will be using these for fenders and such. possibly pulling on frames a little. nothing crazy as this is a hobby garage. curious to see what options i have that sits flush to floor while not in use and i can install before the poor...

looking forward to insulation pictures! nice build!

Agreed 100% greg13! This building im after is built for 45psf snow load, 12 gauge framing, 4' centers (instead of standard 5') and 140mph winds. Our area is 35psf snow load and 90mph wind so i think for my area, i am "over built". I really appreciate yours (and everyones!) Feedback. Thank you...

They company claims they do not offer thermal break tape. The only 2 options are the double bubble and woven r17. But they want $5,850 for the woven installed on all walls and roof and $2,900 for the double bubble. Im going to stay away from the bubble insulation but i think thats an insane...

So they gave me 2 options.. The bubble insulation and a woven r-17 Should i just opt for the thermal break tape and use foam board? I called the inspector and hes not too familiar with steel buidlings and said we'll have to go with whatever the blueprints call for as far as the foundation...

Thanks all, a lot of information to take in. Im located in PA, my Zip is 16333. We are close to a snow belt but are not in it. So if i have them instal the installation, im guessing they put it between the frame and siding? Thats what keeps the frame from sweating too? Will i need a vapor...

thank you for the help! ive been researching and your username seems to pop up a LOT when it comes to steel buildings. any certain questions i should ask the inspector about the foundation for the anchoring? i know a little about buildings but nothing about anchoring them, especially a steel...

Yes, it does come with both Sent from my SM-G920V using Tapatalk

I am not sure but i sent him that very question. Sent from my SM-G920V using Tapatalk

Hello, ive been in touch with a company to have a steel building installed on a slab this summer. Im planing on a 30x40 with 3 doors. Two 10x8's (frame outs for insulated doors) and an 8 x 8 on the side, nothing special. But im wondering how sturdy i should have it made? I opted for 12 gauge...