Recent content by 8Valve

Denmark is very beautiful, as are the people. I had a great assignment. However at times getting around by my self with english only, could be challenging. However my favorite is Norway. Coastal Norway, north of Tromso. It too is very beautiful as are the people and english was/is never a...

When I was in High School, I took shop each year. The shop teacher was good, he really wanted to teach us. I learned how to run a lathe and Mill and weld. That was 57 years ago since I have run a lathe or mill. Welding has been done my entire life. I decided to buy a Lathe and Mill and learn...

They sure do ! I was to busy with business to spend time on the web. 8valve

LXcam, Thank You. The builds are fun and a huge challenge. For 32 years my hobby was antique Chris Craft Boats. Got burned out in boats and switched to PW's. Before you pick up the first wrench or plasma, I had to accept this little rebuild may take a few years. So take your time and do it...

Thanks for the kind words, fun trucks to build and drive. 8valve

I was in Hillerod, DK. Electronic design. 8valve

Looking for a affordable Bench Mill or Mill/Drill. Dont mind if it needs some work etc. Must be located within a reasonable driving range of Schroon Lake NY 12870 Adirondack Mts 8valve

The following link will take you to my Image Event Site with complete builds of 4 Dodge Power Wagons and a Jeep CJ-7. All with Cummins Diesels No the Corvettes dont have Diesels LOL www.imageevent.com/moosecreekmaple 8 Valve

My shop is about 1200 sq ft. I heat with a pellet stove. With stove turned down when I am not working a 40 pound bag of pellets lasts about 24 hours. When working and heat feed turned up my shop is 68 to 70 when its well below zero outside and runs about 15 hours turned up 8valve

I joined back in 2013. Soon after joining I was assigned on a project in Denmark. I am now back and retired. Looking forward to being a part of thie great forum 8valve

Bump

I picked up Watco 303 HC that had a very slow jack up and creeping down issue. During disassembly, I found that the main piston seal and the pump seal was seriously deteriorated. There was also some marks in the release valve. After a serious cleaning and blow out, I put her back together...