Recent content by acecobra

Does anyone know if the dewalt dcf 890 and 887 have the same specs for torque ? I have the 887 and was thinking about picking up another one and swap the hex for an anvil, I like to have a 3 speed setting and it also has an intelligent torquing feature. Thanks !

That what I was thinking, put them I a separate box for stuff like that or backup for warranty exchanges via mail.

I don't know if you can tell by the pictures, bit the ones with the slots from top to bottom are the made in china one, the one without is the made in usa one, and the other one is gearwrench. The drive squares in my M.I.C ones are slightly wider and long and so there is no friction between the...

I’ll post up the differences in the drive then you’ll get what I’m taking about

That’s what I’m probably going to, I like the canvas idea but the socket rail I’ll be using are from harbor freight and they’ll probably break in the bag.

I was using them until a socket few off and nearly broke my car window(the drive end is a faulty design). I had to upgrade I was a craftsman fan boy but they have been putting out rubbish lately and I don’t want you use them anymore.

How do I organize the sockets in the bag ?

I was thinking to do that I just have to find a hand held tool box that would fit the tools.

The impact is new, is the Chinese made craftsman they don't have dents. They have narrow slots running top to bottom where the indents should be, and sometimes they just use a tiny piece of metal to sit behind the ball dent. They hold well on a ratchet but not hog rings. I have the grey...

Yeah but not for nut busting.

Hi everyone, I just wanted to get some ideas, a little background. Two-three years ago I purchased the Craftsman 334 piece tool set and was very excited but then found out they where made in china. I got over it after a while but still sighed from time to time. The set really came in handy and...

Can I use a thicker friction ring ?

The chrome sockets I have don’t have a good detents just a tiny piece of metal, the still hold on a ratchet. The rest of the inner socket is smooth

Hi everyone, I had a question, I have the Chinese Made 334 piece craftman mechanic tool set; I tired using the sockets on an 3/8 impact wrench with a friction ring but some sockets fit snug others don't. Is due to the sockets being circle punched vs sqaure? Has anyone else had this issue ? Any...

I saw that yesterday, I was thinking of making my own setup but now i'll think i'll just go and buy one.