Recent content by acidise

Got a 98 1 ton. Went through the same thing. Use synthetic 75 w 90 in the diffs. atf in the xfer case if it's a floor shift. Auto push button = fancy gm only oil. Same as above. Check owners manual cuz some diffs need "friction modifiers" additive. Usually only if it's a limited slip/ posi...

All good advice. Fuel burners make lots and lots of moisture and will rust everything. They also need ventilation, definitely get a co monitor! There are some mighty powerful electric radiant heaters that would do the job safely. Find dpelletier on this site, he uses one.

im a heavy truck mechanic, snapon prices ****, mac is a bit better, I love snapon ratchets. if you have to buy a ratchet, get the locking flex head high tooth count ones, simply gorgeous and work amazing! haven't broken one yet and I've sniped them all! only the 1/2" drive torx screws keep...

If you have tall enough ceilings, radiant tubes are going to be absolutely quiet! but they heat objects, not air, so until the stuff heats up, the air will be frosty! Looks good though man!!! good thing, you look all closed up just a couple weeks before we got snowed on!!! good timing

Hi, I've got a garage and I can't believe how quick it fills up with junk. I could not imagine the space constraints with baseboard heaters that would cause me. definitely go for something overhead. I have recently found out a lot of places wont sell the heater unless it goes thru a licensed...

check compression too, does it die when put under a load, do you have to pul it very hard to get the rpm up before it will start? and try pulling the exhaust off, they should still run fine (no power though) with the exhaust off. Also check the reeds, i dont know anyting about this suzuki 2...

see if you can ask a snapon or mac tool rep. or call saab and ask a mechanic.

i dont live in an area with pawnshops but the ones i have been in, Calgary Alberta, Canada. Are ridiculous priced! in a bad way. 1980's motorcycle helmets for like 100 bucks, just dumb. I did get one good deal once, a snapon rolling torque inch pound wrench, 0 to 250 in/lbs, or 150 in/lbs...

the cv crimping pliers are $15 here in canada, but they dont do all cv bands, there is a $45 buck one that is made out of a piece of tin foil with a little part that isnt attached to the tool and renders it useless if lost. those are the ones you want. lol. i know because i bought the one you...

i read an article on i think the thundercat? the nascar gun! 15 grand per gun! a 1/2"!!! off topic, i was thinkin it was the nitrocat but it came to me as i wrote this

i shall name it ThunderThorSmashulator! good luck

Hey, You said you are using solvents and a wash tank under the heater. any kind of solvent, spraycan propellant, glues, gasoline fumes, wood dust, can all rot out your burner prematurely, not to mention simply EXPLODE once it kicks in. I suggest a separated combustion unit that eats outside air...

Hi there. Could someone in the know please list the natural gas pipe options and such Running gas from meter to garage, meter and garage are about 3' apart (meter in between garage and house) The plumber im talking to (when he has time) says "T into the main line on house side, up and across...

Hi there, if it is listed somewhere, could you please point me to it, otherwise. Installing a 45k BTU modine or Reznor separated combustion NG heater in a 25'x25' x 8' insulated detached garage in Sundre Alberta Canada. 3000ft, -40C is common in winter. (last winter we were the coldest palce...