Recent content by Aftermath

  1. A

    dw1's barn

    Look's great! I've got the same size only 14' tall. You'll love it!!!
  2. A

    Subpanel Help.

    I'd find another electrician who is willing to work around your needs and not his. Unless there is something I'm missing, I'd go 100amp.
  3. A

    How did you run your wire to electric heater??

    I don't think you are going to get enough BTU's out of it for that size shop. You would most likely need a couple units.
  4. A

    How did you run your wire to electric heater??

    It's a Fahrenheat FUH54. I have one and it works great. Wired it up like the picture in the previous post. http://www.amazon.com/dp/B0000AXEZV/?tag=atomicindus08-20
  5. A

    Wire size for garage

    Every inspector is different! I would just make a call and ask what they would like to see. No more guess work. D.
  6. A

    pole barn shop quote, YIKES!!!

    I am just finishing my 32x48x14 pole barn. I built the entire building myself. The only thing hired out was the garage doors and concrete floor. Shingle roof, vinyl siding, 100amp electrical, water, 11 x 20 loft with insulated room below, 1-16x12 insulated overhead door w/opener, 1-12x12...
  7. A

    3way and half switched, im going mad trying to figure it out.

    First off...I'm not an expert! Unless you are able to run all new wiring this might be difficult. You need to run 14/3 (15amp) or 12/3 (20amp) to each outlet, connect the black wire to the bottom hot side of the outlet, red wire to the top hot side and then break the connecting tab on the hot...
  8. A

    30x30 new garage

    those look great! I might have to look into those for my small shop. D.
  9. A

    Introducing............... the DAN CAVE [30'x48'x14']

    Rarely does someone say..."man, I wish I would have built something smaller!!" D.
  10. A

    How to insulate this?

    I would just put batts in. Either use batts with kraft paper or unkrafted with 6mil plastic. The kraft paper or plastic will be your vapor barrier. Vapor barrier almost always gets installed on the warm side of the insulation. D.
  11. A

    Thermostat for Mr. Heater Big Maxx

    You should be able to use any brand thermostat. A simple dial thermostat would be the cheapest. http://www.amazon.com/dp/B000RUJH3E/?tag=atomicindus08-20
  12. A

    "The Showroom- 30x48 stick build"

    If you are willing to share...what did you pay for them to spray foam 2" first? Thinking of doing the same thing in my build. D.
  13. A

    40x40 build starting... and goooo...

    what lights are you using? looking for something similar for my build! D.
  14. A

    Garage Door Size - One large or two small?

    Thanks for all the input. I think for my application I will be happier with one door. I'm able to use the spac on the sides more efficiently. I'm sure I'll have more questions as I get closer. Thanks! D.
  15. A

    Garage Door Size - One large or two small?

    I should clarify. Door(s) will be on gable end of building. Thanks, D.
See more
Top Bottom