alfadan's latest activity
-
Aalfadan replied to the thread Lincoln "Tombstone".6011 is pretty much all I use, or 7018 on non critical stuff because I don't keep it in an oven. You can practically pick up some 6011s...
-
Aalfadan replied to the thread Lincoln "Tombstone".I keep my eye out for one. I have a hobart inverter, but would like a tombstone or whatever transformer welder for a backup and...
-
AYou can get made to order blades made of whatever tooth you want here. I get my WW ones from them. https://diamondsaw.com/band-saw-blades/
-
AI doubt anyone has a dedicated forum, maybe a thread. The only ones you didn't reference are Vintage Machinery and OWWM ORG Here is...
-
Aalfadan replied to the thread Greenlee 1346 bandsaw gearbox.Yeah, there is very little talk or info on these "contractor" saws. They're simple enough to work on without needing too much, but if...
-
Aalfadan replied to the thread Greenlee 1346 bandsaw gearbox.I hadn't seen that! The gasket material I used was .030 felpro gray paper, probably from oreilly. Good luck!
-
Aalfadan replied to the thread Greenlee 1346 bandsaw gearbox.Glad I could help. Yes, I cut a new gasket from .025 gasket paper as that is what was on there. No sealant used. Without the gasket, I...
-
Aalfadan replied to the thread Best budget dial indicator.Honestly, the Horrible Freight ones aren't too bad for every day use. I like them better than the newer "Fowlers". Also, you won't cry...
-
Aalfadan replied to the thread Angle indicator recommendations?.More dicken' around with my iGauging angle-ator with the above sine bar setup. .1 degree-no reading .2 degree-.200 1 degree- fluctuated...
-
Aalfadan reacted to 1982fxr's post in the thread How to pack end mills for shipping ? I dont have the original plastic containers with
Like.
I did this, then taped them to a piece of cardboard, then bubble wrapped that, then put in a bubble wrap envelope. -
Aalfadan replied to the thread Chain Storage Ideas for a Trailer.I use small buckets and keep the hooks on the edge.
-
Aalfadan replied to the thread How to pack end mills for shipping ? I dont have the original plastic containers.I've had them delivered wrapped up in blue shop towels with the ends folded over and taped.
-
AI have 2 kleins. Only issue I have is they track off by .1 or .2 degrees. I made a note to go inspect the bases of each. Agree on the...