Recent content by andeep

Hi mate, Did this get solved? Interested to see the outcome.

Just finished my second and final coat. I just poured it down on the concrete and used a soft bristled broom to sweep it around making sure there was no pooling. Do I need to wash the surface down after it is fully dry? The floor will be getting 2 coats of epoxy.

What is everyones preferred method of applying concrete sealer/hardener? I'm going to seal my floor and people have recommended pouring it directly on the floor and use a soft broom to work it into the surface. Others have recommended using a paint roller.

The pressure washer isn't powerful at all. Its defo the concrete, the builders that laid it were useless.

All done. I used a 3:1 ratio of water to hydrochloric acid (36%). Applied it nice a thick and brushed it in with a stiff bristled broom. Washed it off with a pressure washer and a heck of a lot of water! Spend around an hour washing it down! These the results (concrete is still wet): A lot...

I am following this video: He has stated to use a 10:1 ratio, but I will do a test to see what works best for me. Alphagarage has said the following on another thread which I will use:

Nope didn't have any instructions to dilute it. Product is rubbish and doesn't do the job properly. Instead I am going to buy hydrochloric acid and mix it with water. I can get hold of 36.2% hydrochloric acid, is that okay? How much do I need to dilute it by?

I have had a fresh pour of concrete in my garage that has had 3 weeks to dry so I decided to acid etch the floor so I could put on my sealer and epoxy paint. I bought 5 litres of the following...