Recent content by Andrewsh

so I just finished rebuilding mine. I did not tear it down as far as the others did. I figured out the 4 bolts holding in the jack, the bar under it and the pin that holds it to the lever, and the pin that holds it to the arm were enough to drop out the jack itself. Plus loosening the pivot arm...

hmm about a foot long pipe. I found the pins are soft and meant to be drilled out. still no good info on how to straighten out square tubing. it is pretty thick. I might consider the filing sugguestion I read somewhere else. It doesn't see it be off that much. but if there is a trick to make...

I am not sure where this goes, but I thought I would try here first. I overstressed an old wilton 744 vice. Made in USA apparently back in the late 70's to 1980. I thought it might be the screw or nut. I took those out of the vice, but they seem to work fine independently of the vice. My...