Recent content by atotalnincompoop

  1. A

    Power maxx bandsaw

    I read that thread, I'm not sure if it's the same brand. Some good info on there. Thnx��
  2. A

    Power maxx bandsaw

    I put in a low, sealed bid for a bandsaw and won the auction at our city's surplus auction recently. It's a power maxx 18" bandsaw, I believe the part number is 1-090-018. I have googled the heck out of this thing and have come up with nothing. Does anyone have any knowledge of these tools? I'm...
  3. A

    basic in floor system tuning

    OK without jinxing anything, the system appears to be working. It has run without incident for a couple days now. The slab has gone from 40 degrees up to 60. Its actually a nice temp in the garage., fingers crossed:thumbup:,
  4. A

    No flow in radiant heat loops?

    mine is a gtflow from pex direct on ebay. not good!!
  5. A

    No flow in radiant heat loops?

    i finally got all the air out of my system , i'd hate to open it up and have to start all over
  6. A

    No flow in radiant heat loops?

    i have a similar manifold, my flowmeters dont show anything, the little red discs are just stuck at the top of each one. mine didn't have any instructions regarding adjustment, i email the vendor and ,go figure, got no response:sad:
  7. A

    basic in floor system tuning

    i've got the pump running on high, the flowmeters are on the return side of the manifold, however this is a cheap ebay special manifold, i know i have flow but they are not showing anything
  8. A

    basic in floor system tuning

    ok, so not wanting jinx anything, here is what has happened in the last couple of days... i picked up another replacement unit, installed it, then i replaced all the 3/4" pex with 1". turns out the guy at the hardware store down the road installs outdoor wood boilers, so i got some advice off...
  9. A

    basic in floor system tuning

    i'm here and she has no idea;)
  10. A

    basic in floor system tuning

    r20 wall and roof:thumbup:
  11. A

    here's what i made today ...

    i dont recall where the tower was, but i loved it down there. that whole area was great:thumbup:
  12. A

    here's what i made today ...

    hey i've been to kirkfield. i built a house on canal lake about 10 years ago:beer: nice job btw
  13. A

    basic in floor system tuning

    YEs, its plumbing pex, its what i had. THe filter was added today as a temporary measure to clean junk out of the line, ill replace it tomorow with a less restrictive one. BY melt down i mean the top of element melts then the wires burn off
  14. A

    basic in floor system tuning

    THe manifold is running with all loops wide open
  15. A

    basic in floor system tuning

    THere is one, just couldnt fit it in picture
Top Bottom