here's what i made today ...

[anthony666]

https://scontent-a-iad.**.fbcdn.net/hphotos-ash3/1488168_10152063700980792_2114919571_n.jpg

it's now beer o'clock, yes i'm bragging, yes i'm an *******

 

[Mike007]

Looks good. Thats not a solder drip I see is it??????

 

[anthony666]

Looks good. Thats not a solder drip I see is it??????

lol, maybe

 

[D.J.]

May I be the first to call ******** on that, you may have installed it on the wall but I find it hard to believe you did all that soldering today. But anyhow, Nice Job, Looks excellent.

 

[atotalnincompoop]

hey i've been to kirkfield. i built a house on canal lake about 10 years ago
nice job btw

 

[anthony666]

May I be the first to call ******** on that, you may have installed it on the wall but I find it hard to believe you did all that soldering today. But anyhow, Nice Job, Looks excellent.

i got a kid that cuts the pipe for me, his right arm would make popeye cry .. cheers

 

[anthony666]

hey i've been to kirkfield. i built a house on canal lake about 10 years ago
nice job btw

small world my farm backs onto canal lake, the cell tower is on my property, south side of the lake

 

[atotalnincompoop]

small world my farm backs onto canal lake, the cell tower is on my property, south side of the lake

i dont recall where the tower was, but i loved it down there. that whole area was great

 

[zmaxmotorsports]

https://scontent-a-iad.**.fbcdn.net/hphotos-ash3/1488168_10152063700980792_2114919571_n.jpg

it's now beer o'clock, yes i'm bragging, yes i'm an *******

 

[zmaxmotorsports]

May I be the first to call ******** on that, you may have installed it on the wall but I find it hard to believe you did all that soldering today. But anyhow, Nice Job, Looks excellent.

It wouldnt be too tough to solder all of that witha decent torch,fitting it all together would of taken a while though!

 

[kbkna]

Ok, I give up! What is it for?

 

[NUTTSGT]

You're going to go back tomorrow to find some drug addict scrapper broke in and stole it all.





Looks good, what do you use behind the copper to prevent burns on the plywood ?

 

[ADSR]

That setup is anything but basic. Looks very impressive!

 

[uniballer]

Looks good. Thats not a solder drip I see is it??????

No ****, anthony needs to teach me this trick!

 

[anthony666]

Looks good, what do you use behind the copper to prevent burns on the plywood ?

another piece of plywood .. and if i do hit the wall popeye arm is there with a hunk of sandpaper gotta keep him busy