Recent content by badinf

X-2 on Apex, thats what we have in the tool cribs.

Here is mine, still a work in progress http://www.garagejournal.com/forum/showthread.php?t=84047&highlight=40x60

Wildfire1, excellent cart, I like the bumper :thumbup:, Where did you find the clear tubes for your rod holders ?

Thanks for compliments. The loft is 10 x 40, I built it to be used mainly for storage. Head room is good in the middle, storage was my main goal with it. I have planned on a lift before I built, thats why I chose the scissor trusses. I am trying to decide on a 4 post that portable but in the...

BUGTHUG, sent you a pm, I looked at your album, nice shop, like the signs.

mustangmccance, not for making a living out of, it will mainly be used to fabricate/weld in and mechanic type work. I have a new mud racer project in mind. I quit racing while getting my daughter through college. With that out of the way the wife said I deserved to build a new shop. My old one...

Thanks for the compliments guys, 69dz302z28- Stilwell Construction out of Stilwell, Oklahoma built my shop. Their number is 1-866-211-8902, ask for Steve.

I have had several inquries about the large CFL's I used in my shop. Finally got some time to take some additional photos. The ones I used are made by EiKO, they are 85 watt, medium. They cost about $23 each and come 10 to a case, I have purchased 3 cases. I have had no issues with them at...

Got a few more things done to the shop, finished boxing in the compressor room, french doors on the small room and attic stairs installed to make access to the loft easier.

Dragging it down a gravel road road works:thumbup:

Mine are at 52 on center, works good for me. I also have some installed at the top of walls in case I wanted to mount fans or whatever up high.

Thanks for the replies, I will scratch this type of heater from my list and look into the Reznor, I spoke with a Heating and Air company to confirm my htg calculation, I need something in the 175k to 200k, for my 40 x 60.

I will have to get more information, I appreciate the replies, I didnt think about some of those concerns.

I am trying to decide what type of heater to install in my 40 x 60 shop, I am leaning towards a L.B. White Guardian forced air 250k BTU, They are advertised for heating big poultry or swine barns. http://www.lbwhite.com/content/spec.asp?m=2&pl=1&rid=1&pcid=1 The thing I like is they have an...

green.bubbly, I sprayed it about an inch and a half thick, 4 kits covered the walls up to the roof line, however I also sprayed my 10 x 20 room about 2 inches thick. I had the roof insulation installed when the building was put up. WTR- I am between Winfield and Udall