Recent content by Bannik254

Just buy the box. Remove serial numbers. This isn't a firearm, it's an overpriced storage box—no serial, no repossession.

Dairy farm wrench probably.

I have warrantied several hex allen impact sockets, my new 8mm, 10mm, 5/16'', and 3/8'' are doing the job, the new ones look very similar to the new Harborfreight ones, though still slightly different at a detailed glance.

Imagine using a $65 pair of pliers for a flush cut when these exist for $3 and do the same job and take up less space. https://www.amazon.com/OXOX-Clippers-Toenail-Fingernail-Stainless/dp/B0C7WJWRZL/?tag=atomicindus08-20 Some folks take pride in wasting their money, I'll take the cheaper...

It is a shame since I think of Starrett as an American heritage company, being almost 150 years old, we lose part of our culture as a nation when these old companies and institutions go under. I know the brand name will continue but what the brand means to folks will change.

Snap-on pliers, notably 415CP and 915CP are worse now than they used to be. Granted, we abuse the snot out of them, grabbing/twisting/prying/etc, they have a much shorter service life needing a warranty nearing every 6 months where the old ones would last years. They tend to fail when...

Use a multimeter to check the start and run capacitors, this does require breaking the circuit so mark and label. You want the microfarads to be within 10% range of the rating listed on the canister. The second step is to verify the mechanical switch isn't stuck open, it is designed to open...

Pass-through Air/Electric ratchet that would allow up to M24 to pass through the socket. It's a niche use case, no market but it would save so much time when you have stupid long threaded rod.

Nothing fancy.

I bought a backup 1/2DR 3/8 Allen impact socket. Compared to my original, its different all around, even the machining was different from the old version. Sunex is going the route of gearwrench unfortunately. Quality Taiwanese brand to China. Old stock Sunex will be around for a while but...

The trick with any electronics that have thread locker, heat up a soldering iron, press against the head of the screw, and wait for it to heat up, then loosen.

Beware of blood blisters! I ended up giving my Merry screw pliers away to a coworker. Every time I used them, I had more blisters. Take modern plier designs for granted I suppose.

Wipe dust and debris off of the grease port, put screwdriver tip to the outside of the bearing housing, pump grease til you hear noise frequency change. Sometimes it doesn't take much at all on smaller motors, bigger ones take a lot more. If bearings are sealed, greasing is pointless and if...

Price went up considerably.

I like the ideas and technology behind EVs, I think EVs are inevitable for those living in urban environments. That said, I simply can't stand the culture of EVs. I can't stand the people pushing EVs on us. I can't stand the people adopting to EVs. I can't stand society in general tbh.