Recent content by BigBrian

All done. Ran it in and tuned it today, she rips!

Thank you

Like this then?

Thanks guys!

Hello all, I'm feeling a little stupid today... I am trying to wire a panel in my new detached garage. I have 2-2-2-4 ran from the house (not hooked up in the house panel yet). The problem I have is this, the wire isn't color coded. The 4awg has a yellow stripe but for the 2aw wires, one says...

All done! Spoke with Wolf Creek Saw Shop and they said the cylinder is essentially a "press fit" and to use my original cylinder bolts to draw the 2 halves together. So that's what I did!

Yep I bought it from Wolf Creek. It appears to be in the correct packaging and everything else looks like it's in the same place as the original but yeah unfortunately it's a no-go. I've called them and left a message this morning, I'm sure they will make it right.

Well I finally got home after 3 days of sales meetings and went to put my saw together but ran into yet another problem... The cylinder is machined incorrectly. The 2 halves of the clamshell cannot seal. The bearing recesses are machined incorrectly. I have a 3/16" gap all around when the...

I didn't know about the ignition issues. What goes wrong? Coil problems I imagine.

Too late now. I went fairly mild on the porting so it should be tuneable while increasing power.

Said "why not" and modified the muffler. Didn't want to go crazy so I just opened it up some. Still debating if I should drill the center out. Rinsed the muffler out good with hot water and used my heat gun to dry it after I was done.

I appreciate all the information! As far as the 2 stroke oil as assembly lube goes, I am not planning on using a ton, just enough to get everything coated and slippery, certainly not enough to pool in the lower end. I actually did pull the carb apart and give it a dunk in my sonic cleaner to...

Still no parts, and I have a week of sales meetings coming up so I won't have time to work on the saw even if I had the parts... sigh...

Still waiting for my local ACE to get the rest of my parts in. They said the parts would be in sometime this week thankfully.

No worries!