Recent content by Bigezee

That is all I needed to hear. thanks all

I picked these up at an auction and realized that they are both Part A and i didn't get the Part B for these. - Can you still buy just the Part B for these? - Would they be any good as the pic shows they are 8-9 years old. Does the mix go bad after sitting so long? thanks

Off topic but you should probably watch a few episodes of Holmes on Homes, especially the episode about how home builders skimp on the insulation above garages. Spray foam and proper heat ducting will probably be the only way to keep the room warm.

Yes I think they are just on sale locally too. Probably going to go back and buy all they have in stock. I wish I hadn't seen this thread!!!

Just found these at my local Rural King. They are made by Tool Shed They are exactly the same as the Harbor Freight ones to the tee! They are only 5.99 regular price!!

The best stuff I found was at Rural King. It is sold by the foot and is 4' wide. It is a black rubbery mat almost like rubbery cork material. May be a little thick and you might lose tool space if you have very shallow drawers but the stuff does not move.

Cool idea. I have never seen these before. May pop up on Ebay sometime.

Here is mine. I got it at the local Rural King for just ten bucks. kinda the same as yours?

Got it working!! Thanks to MTW for his help. I did exactly like he said and it worked first time! This buffer has been down for months until now!! Thanks again. Not sure what a potting agent is but I just used the silicone to mount the base to the motor. It has been open and drying for over a...

Thanks for your reply! Will use your help and try to get it hooked up. At least you have given me something to try...thanks!! lol. I actually did put loctite on and lo and behold the small fine thread screw was stripped out to begin with. Gotta love this cheap Chinese metal. I got pissed and...

I need some desperate help rewiring my new Buffing motor. Long story short the motor vibrated loose from the base and pulled all the wires off. I tried to hook it back up and the switch burned up and now I have nothing but what is in the picture. I tried to get help at the Eastwood forums but...

Would be happy for just a general schematic of a basic capacitor start bench grinder.

Thanks for the response. Switch was at the bottom of the picture but already tried that . they are all the same length and could go anywhere.

I need some desperate help rewiring my new Buffing motor. Long story short the motor vibrated loose from the base and pulled all the wires off. I tried to hook it back up and the switch burned up and now I have nothing but what is in the picture. I tried to get help at the Eastwood forums but...