Recent content by BleedingGums

I picked up some dry lube and dressed the bushing and the skinny part of the screw pin with some 120 grit sand paper (I also made sure the bushing was inserted the same way as it was originally). Small improvement in the movement, but upon closer inspection, the skinny end of the screw pin (the...

Thanks for the replies. FWIW - the bushing fits into the bore hole no problem. Rotating the bushing within the bore hole is a good idea, if I can find a mark on the bushing from the set screw, I should be able to get the bushing back to it’s original position. Thanks again. Luke

Thanks for the reply. I lubed the outfeed table parts with wax and they seem to be OK. Didn't want to use oil or anything that would collect dust. The infeed table parts are the ones giving me the issue. Have only test fit them together so far and have not yet applied any wax. The binding of...

I recently acquired a Rockwell/Delta 37-220 that I tore down and am now reassembling. Not sure of the age, but I'm guessing 60's. The bearings on the cutterhead are different sizes, which according to the parts diagram I have this would indicate an "earlier model." The bearings that came with it...