Recent content by bloodvette

I've always been told 6mil polly should be the bare minimum 10 is preferred... I have a general contractor I work for who insists on 10 mil becuase he's opened up a lot of walls and found mold due to thin/torn poly. I am an electrician, you said a "75k heater"? based on 6 amps at 120V that will...

According to this pumping drawing I drew up, Is it possible to fill my infloor radiant system by using the circulation pump? I noticed of all the plumbing layout pictures I've seen, people usually use a seperate pump to fill the system, but I don't see why you can't just use the one you already...

Actually if anyone has a picture of their layout please post!!! Thanks

So, I'm about to start plumbing my infloor heat in my new shop. The pad is 32'x32', I have 4 circuits layed out with 1 foot spacing between lines. So that's eight- 1/2" lines coming up out of the corner of the shop. I pretty much have everything I need except the isolation valves. I bought 2...

I'm trying to roughly calculate how much tubing to buy for my 32x32 pad. I know it will be 5 circuits, and not more than 250' per run... am I then going to use up 1250 feet? Looking online for advice, before I do the inevitible graph paper with string... my dad's pad is 28x36 and he said he...

i have a 56x32 pole building that I've decided to make my workshop. I'll pour a pad in just over half of it and the size will be 32x32. Forms will be strapped to the inside of the poles and they'll be pressure treated so they can stay there. I'll put 2" extruded polystyrene high density down...