Recent content by Blownchevelle68

Ok thank you! Sent from my iPhone using Tapatalk

Gator mulching blades work well however a high lift blade without the mulching ends, will have a nicer cut VS mulching blade. I only run mulching blades the first 2-3 mowings, then last 2 each year for my customers, and even then, unless you have baffle that blocks the chute and makes it a...

Thanks-Since this runs above false ceiling in a bedroom, should it be in pvc, steel or just the romex?

Hello- Did some searching on the site and could not find an answer.....I'm renovating my attached garage and will be putting in a new 100a service panel. Main panel for my home is in the basement about 25' away from garage. I have a couple options for running my service to the new panel...

Pulled all the drywall this week, ceiling included-Over 2500 lbs of drywall to the dump! Once the wiring was exposed we noticed several overloaded gang boxes, a couple wires were dead ended and live and many wires were run over the top of the trusses, then sandwiched with a sheet of plywood for...

Thanks-Anything I should be spraying in there now? Should I get some of the cans of spray foam and pull each roll of insulation out, spray the perimeter around the 2x4 then reinstall insulation, followed by plastic sheeting?

Hello all I have a attached garage i'm starting to renovate. Currently drywalled and insulated with R-11, but taking all the drywall out and replacing. Couple years ago I wrapped and re-sided the house, using vulkem on the end siding to seal the gaps. The R-11 insulation I have in...

Thank you all! I've posted a renovation project as well now. Have been getting a lot of good ideas from the site! Sent from my iPhone using Tapatalk

After really looking closely at the drywall last night I've decided it will be best to pull all the old and start with new. I found 5 patch sections in the ceiling and at least 3 patch sections on the walls. Along with the heavy texture that I really don't care for, along with 7 or 8 joints...

Thanks for the info! I thought about sanding down the texture as well, what is the easiest/best method? I found last night that at least one of the spots, the tape did not fail, it was the heavy texture covering a joint, formed a crack over the tape. Tape was still intact below.

The drywall is solid, it's just a couple three area's where the texture has cracked. I got to looking at it last night and cut back an area where I thought the tape was bad. It was just the heavy texture that was sprayed on the walls at a few joints has cracked-the tape below it was intact. So...

Your spot on. I love to be in the garage. Grew up around cars, dirt bikes, ATV's since around 7 years old. My main hobby has been engine building/racing hot rods. Also a high stress job leads me out to this place to destress, so having a nice shop will really make a positive change. Right now I...

Not the greatest pic, taken just after new engine build about a year or so ago. Looks like you've got a project as well?

Had a quick minute last night to get a couple pics of where I'm starting. Garage is 19WX28L. Garage was built after the home was finished, basically butting it up against the home. They didn't bother to take the siding off the house, just threw it up there, ha ha. Bench is in nice shape and very...