Recent content by bmxdad

I looked and couldn't find the TALL kit. I have a MK2 mmu and would like a little more Z.

Sounds like it's twisted. Looking down on plate, it would have rotated a degree or so, so that the plug that is sensed is to far off spec to be compensated. I did the same thing with a bed heater cover. Needed to loosen rails and realign it.

Not a project yet, but want to make this year. Square tubing and some wire, and scaled up.

For all of you with 3D Printers ... there's a Facebook site that is looking to get some Ventilators printed for HealthCare Providers ... check it out if you can. There might be more, but this is who I'm working with now. https://www.facebook.com/3D-Printers-United-111949070436011/

3 hour print. That's for my MP Shield 45. I also did one for a 40 Beretta double stack. They seems to be holding up pretty well. It's what I was asking about for the Annealing. I was concerned about layer separation, but seems to be holding fine. ... so far, knock on wood.

Latest print. Works pretty good to.

Tuned and prepped the Mowers, for the long hot summer that's coming.

Kind of curious about machining the sway bar. Aren't you concerned about it breaking at the thinned area? I've heard of front torsion bars breaking because of a bad bushing wearing into the bar.

Looks good. You have any experience with the Bear Upgrade? Thinking hard on it with my MK2 MMU

They went from $0.125 to $1.50 KWH? :shocking: WTF ... I'd be P.O'd

Has anyone tried to anneal PLA by boiling it? I have some hooks I made and was wondering if it would be worth the effort.

That's exactly what I was looking for, thank you ... Thingiverse needs a better indexing system. There is so much stuff that's just buried.

Spot on ... The more you understand the slicer the better your prints. I use PrusaSlicer and love the ability to have multiple layer thickness's through out the print. Lets me have smother transitions on corners and stress points. I have an older Mk2 MMU, but it has upgrade rails and bearings...

Is that your design or something from Thingiverse? Link?

24'x36'x9' ... next one will be 36'x40'x14'. That should last me awhile.