Recent content by bobbyg313

Sunex 21mm, 22mm, and, 24mm 1/2" drive swivel sockets. Matco had a BOGO deal on there 16" needle nose pliers. I traded in an old/broke Gearwrench long needle nose, so the set ended up costing me, $81. Not a bad deal.

I'm either going to buy that or the ,W5131P High-Cycle Cordless Impact (3/8 20 volt ingersoll rand cordless impact)

Thanks man. Yes, I love the height of it! I'm out of Athens, not too far from you and, our Matco guy comes by on Wednesday's

Thanks man! It's 25" deep.

I'm paid off a commission, it has it's ups and downs. Thanks man!

I didn't trade a EPIQ for this box. A 68" EPIQ is a larger box but, this is much larger and my classic 96

Traded in my, KRA2418 (classic 96) for this 78" triple bank Matco box. The Air hammer, Cobras, and, OTC Tie rod tool, were part of the trade. It took about 2 Hours, to get everything, re-organized. Beside a 60" EPIQ

Thank you sir.

Yeah, no problem. I'll take some tomorrow. One of the main reasons i traded in a snap-on box for this one was, only having one 50" drawer VS three.

Traded in my KRA 2418, (classic 96) for this, Matco 3 bank. The tools, on top were part of the trade.

Great deal on a great box man!!! :thumbup::thumbup: Nice vette btw

YUP could not resist hiding inside and jumping out the top when someone walked by worth every penny!!

Thank you sir!

HAHA yeah i guess so, but it took 3 weeks to get here!!

Yeah thats where its at for now. Good eye :thumbup: