Recent content by bora

How did you make the bubble flare ? Did you run the flare on the flat side of the bar?

Definitely going to use copper /nickel line when do the next line.. From all the post seems well with the extra cost . Does the Mastercool do steel lines? Thank you all for the help .

Yeah I had to do the same, the flare wrench kept spreading . So as you said cut the line and removed it with a socket.. I’ll checkout Carlyle, but looks like I need to get a snap on set . Thanks everyone for the advice !!! Much appreciated

Hello Everyone So this morning went to drive my van, and one of the brake lines were leaking so off to Nappa , to pick up some brake line , fluid and fittings . I have the Cal-Van Tools 165 Master Inline Flaring Kit, I have the upgraded dies black steel , over the aluminum ones that came in...

Could you not cut the floor from above , this would help a lot and also repair any damaged cages I did this on my Gbody, pain but had to be done.