Recent content by bradform

Question for you guys. I know quite a few folks install a radiator or pipe style air dryer between their pump and tank to reduce/eliminate moisture buildup in the tank. My main question is has anyone installed a refrigerated air dryer system before the tank with the same objective? I was looking...

Update #2. I fired the compressor up before reinstalling and have run into another issue. The tank has a small air leak in the bottom from where the PO didn’t drain the tank regularly. From what I’ve read, welding a leak from internal rust isn’t the smartest option. I’ve found an ingersoll rand...

All, Update. I've taken everyones advise and returned the 220 volt stuff and plan to go with the 120 volt set up. My compressor will be located under a shelter outside my shop in middle Georgia. Does anyone think I'll have operational issues with the auto drain in occasional freezing...

Handyandy23 Thanks for the quick reply and confirmation. I swapped the posts yesterday so the pump/tank is on the passenger post. I obviously wanted to get this done before anchoring the post during my install. No regrets down the road! Sent from my iPhone using Tapatalk

I was wondering if you guys have a preference on the side location of your power unit for a symmetrical two post lift? I can bring power to either the drivers or passenger side post. My gut Is the passenger side would be best given you have to get in and out of the drivers door. On this lift...

All, I’m working to install an older Magnum 9K symmetrical two post lift manufactured by Bendpak. It’s a PR-9CX model made in 1996. My main question centers around the placement on the floor in my shop. The space I have on the floor is 19.5’ x 19.5’. The ceiling is sloped, but the minimum...

This is the wiring diagram from the referenced plan in the original post and video. Again, this compressor does not have a magnetic starter and runs only on the pressure switch. Below are pictures of my system.

I debated whether to go with a plugin 120V system, but changed my mind after seeing this video and instructions. Sounds like I may have pulled the trigger too quickly. The instructions I was referring to in my initial post are below: DIY Auto Drain for Your 220V Air Compressor! Extend the...

I’m in the process of adding an automatic drain to my shop air compressor. The compressor is 220V single phase 5 hp run with a magnetic starter and pressure switch manufactured by Square D. The compressor is manufactured by ACS. The timer switch and solenoid valve I’m adding is below. Baomain...

I just purchased a workshop and can’t seem to find specific info on the compressor that’s installed. From what I understand, it about 20 years old and was used vary sparingly (the guy had a business he shut down )Can anyone help me identify the make and model or where to look for it. Thanks in...