Recent content by bryan583

https://photos.app.goo.gl/nawgL5fTJHyxb2gv7

Its been a while and I put this on the back burner for a minute. Just pulled this back out went through the pump again. Veins were not in the correct orientation, fixed that verified im getting suction and had a small bottle of fuel to run from. It fired up finally. Put everything back...

Im still here! Where to start....... I understand the better why not to use the plug as a both a welder and generator. I will only be using it for my welder and air compressor. Which I corrected above is a 3HP. Im not running this wire through a wall. My garage is finished already, I am...

*Correction the compressor is a 3HP I have attached pictures of the wire and the generator plugs. I have currently used the twist lock 30 amp but wanted to be able to run off the 50amp. My intention was to create an extension cable (ref :suicide cord??) with the same ends so I could to run...

Welders are everlast rated for 50 amps. Compressor is 5hp. They wont be used as the same time. Also i should have mentioned Im wiring a NEMA 14-50R. Then making an extension cord adapter to convert it to a welder plug. 6/4 wire is common for generators and ranges because it rated...

Hi all I joined a week or so ago and been reading some amazing threads. So a couple months ago I switched out my electric range for a gas range. Scored points with the wife while not telling her I really just wanted the 40amp breaker for my welder/compressor. 😃 I have been using a 60ft...

Guy I work with gave me this heater, hes not a mechanical guy and just bought another. Its a All-Pro 200T multi fuel torpedo heater. Upon first tryin to fire it up i drained the fuel and replace with K1. The glow plug warms up and the fan kicks on. The fan then cycles 3 times and after...