Recent content by camaron32

I've been looking, without success, for a hand pump for a metal rectangular gallon can of WD-40 and Seafoam. Has anyone been able to find one? Or even an pump/container set that I could transfer the product to? Any help would be most appreciated. Thanks.

I've got a Blue Point AT192A high speed saw and I lost the manual that came with it. I tried calling Snap-On and KKU (a Blue Point manufacturer) for something downloadable without any luck. Does anyone know where I can find it or get a PDF? Thanks.

My father-in-law gifted me his Snap-On tools when he retired. Unfortunately this came in the way of a lot of 5 gallon buckets. He bought tools from 1990 to 2015. Does anyone have an idea of how to get a list of tools that would come in a set? Eg. a punch and chisel set.

My father-in-law is a retired mechanic and he is gifting me his Snap-On toolbox with Marco side boxes. Is it possible to have them all keyed alike?

I have a Stanley 675919 portable space heater which I use out in my 20x22 garage. While I have no expectations on it being able to heat the garage, but it falls very short of my needs. I can stand 3 feet in front of it and feel absolutely no heat or air movement. I'm looking for a 110 volt space...

I have a Craftsman rolling 5 drawer project center that my Father-in-law donated to me. It has those crappy slides and I want to upgrade to better ball bearing soft close slides. The ones that I have are 15.5 inches long but the drawer itself is about an inch longer. Could someone please advise...

I thought I had it in my profile, but I live in Minnesota. So the temps will be below zero for 2-3 months out of the year. I'm not looking to heat the garage up to 60 degrees. I just don't want to freeze my backside off. LOL

I am looking for recommendations for a portable heater for a 22x20x10 garage. The wife and I will be moving next Spring so I'm not looking to install anything. I'm not sure if the garage has been insulated before I bought my house. I was thinking infrared because it would heat objects and not...

Cool. Thank you for the help.

I know that grease zerks can vary where they screw or press in, but are the rounded ends a standard size? I want to put caps on the zeros for my Ram 1500 and my John Deere riding mower. Any advice would be helpful. Thanks.

Cool. Thank you.

I bought a Black and Decker 9403 type 2 6 inch bench grinder from a friend.What I'm having trouble finding are the round safely covers, plastic eye shields, and a wire wheel. I've not been having any luck finding these parts. Do you have any suggestions? Thank you.

Well, Gol-Dangit 454ragtop and Mohawk Dave you just learnt me sumthin'! I just took a piece of wood and clamped it down and the head wouldn't rotate. This is when experience trumps all. I've looked online and I've looked on YouTube. Everything pointed to a defective vise. Now that I know...

I was looking at the parts diagram again, and it looks like the locking bolt that goes in the side of the vise is missing. As in it was never drilled from the factory. But it looks like there are two hex bolts on the rear cone. I tried tightening the hex bolts but it doesn't seem to make any...

My dad gave me this multipurpose vise a few months ago. I've figured out how to keep the vise from moving right to left, but I haven't figured out how to keep the head from rotating around. Anybody have any ideas? I wasn't able to post a picture, but here's a link...