Recent content by Captain Ledd

Yeah, I'm with CarCrafter, these lifts are NICE!. However, I do believe mine could have been a bit farther back on the trailer, but the guy who loaded it insisted on more tongue weight. I guess it drove well enough, but I think there's probably around 800-900 lbs on the tongue (my trailer...

That's a 16' ceiling, 30x60 un-insulated steel shed with the old horizontal sliding doors (12'x12') on tracks. also almost twice the square footage (1800 ish) Pretty far from ideal at holding heat. I also don't spend every single day in the shed. I'd have to imagine a smaller, remotely...

The first post is a year and a half old.

We have a 200,000 BTU diesel heater for our Quonset Hut. Heats the 30'x60' un-insulated steel building pretty well, even better since we put the industrial fan up top. At 25°F it could keep the shed at a good 55-60°F. May not be the nicest/fanciest option, but it should run you only $200-$400...

A broken antique pipe wrench. Edit: Blast, too slow. Had to find a decent picture though. 2nd Edit: Dang, came back and it reloaded another picture before mine even...

I also called earlier today. I'm really hoping to hear back from you!

I got re-directed here from another site to Aahz's post about some 2-post lifts. I'm reaching the point where I pretty much need one. I'm gearing up for a full frame swap this spring on my Ranger, and getting more involved with rebuilding engines, transmissions, axles and swapping engines...