Recent content by CarreraX

Can you still get a car in the next bay over (parked normally so 2 will fit in the big side) without hitting the post? I think if I leave that much room on the close side, the lift will be in the way of the next bay.

Im getting ready to order a 2 post from Greg Smith and I need to put mine right up against the wall due to the location of the single garage door (3 car garage) and the location of the other post would be in the way of pulling a car in the double bay. Not a good situation but not many options.

The lift is considerably wider than the garage door. Maybe 30" or so from memory. Ill need to favor the lift to the right offset from the centerline of the garage door. This would mean the car will still be maybe a foot towards the left side of the lift because I cant get the car to the...

Ok, newbie with a few stupid questions. I am actually getting ready to buy a BP8000 from Greg smith (I think unless there is a better option). It is for my 993C4S. My area is a bit tight. It is in the 3rd bay of my garage and I need to raise the ceiling a bit. The ceiling isnt a big deal in...

What brand of NG heater do you have? My garage is very similar. Thanks!

Steve, Great thread BTW. Im also considering what type of heater to put in my attached 3 car. Regarding the gas lines, I just had gas lines run into my kitchen for a new gas range my wife wanted. I paid to have it done. After it was done I realized that I needed to make some changes to it...

Thanks Srode. That makes sence. So I can go to the walls etc but basically stop short so there wont be any to blow off. I see what you mean about the stripe part. I would have done that!!! Thanks! I owe you a beer!

Ok, Im doing my epoxy coat floor tomorrow. My garage is 660sf. Im obviously doing it in sections but need to know as you broadcast the flakes per section, what do you do about the flakes that land on the places that arent coated yet? Blow them out before coating or just pour over them and dont...

Im having the same issue as to where to stop. I hate to stop and make a straight line with tape. I cant imaging that it would look too good. Any other ideas how to hide the line?

Bluesman, Thanks for the great thread! I just ordered 1 1/2 kits from epoxy coat and am hoping to do it in the next few weeks. I am also doing the flakes. I ordered the non slip grit but Im really on the fence as to using it or not. Im in Dayton Ohio and we get our fair share of rain/snow...

I just requested a quote for 450 tiles. Hopefully both discounts are included. Im ready to order as soon as Im 100% convinced I want RD instead of epoxy. Tough decision.