Recent content by cavediver

Hi Gang, I am still considering the porcelain tile route in my workshop, and will probably be tackling it later this fall. In preparation, I am trying to develop a game plan, and prepare myself (mentally?) for the task at hand. The shop is 20x30 with a concrete slab that was poured 6" or...

Can we expand the number of threads one can view when clicking on "New Posts" beyond the existing limits? I have it set to show me 25 posts per page, but that still often leaves me with 10+ pages of threads. I typically click on "open in new window" on each title that interests me, then go read...

Strange... Mine goes down to 4.5 ... Oh wait :lol_hitti

What level of "flatness" is required before laying tile? I have ~1/4-3/8" variation in the surface of my concrete floor over an area of about 4-6 feet (a low spot that collects melting snow/water). I also have another low spot right along the bottom of the garage door seal so it doesn't close...

Has anyone tried this type of LED T8 replacement option? It is a 120V "direct to the tube" solution where you essentially bypass the ballast and provide line power to the tube. I was originally intending to install 21 of these "cheap" fluorescents in a 20x30x12 shop. The issue I am mostly...

1. Draw a triangle inside the circle with all three points touching anywhere on the circumference (sides of triangle do not have to be even). 2. Draw three lines, one from each corner of the triangle, to the exact centre of the opposite side. 3. All three lines should cross in the exact centre...

Tablesaw has been Sold!

Hey group, I am selling a 3HP Delta Unisaw with the 52" Unifence. It has a 240vac single phase motor. Right tilt blade. There is nothing wrong with this saw other than some cosmetic issues (such as the last 3-4 inches or so of the tape measure on the fence has worn away - although it is easily...