CGT80's latest activity
-
CCGT80 reacted to clinto's post in the thread Duty cycle on air compressor requirement, automatic drain valves for outdoor environments with
Like.
I have (seen PVC fail). At a former place of employment. Too long of a story to type out. They didn't listen to me and got what they... -
CThis is haze gray from Sherwin Williams. I like solid colour, you can see everything.
-
Cthere is a color called 17% gray which is my preferred floor color, as you can find anything on it. Those USB walls - THOSE would drive...
-
CCGT80 reacted to The Cobbler's post in the thread Why don’t pullers use acme thread screws? with Like.
Acme threads deliver lower mechanical efficiency than standard V-threads due to higher friction from their trapezoidal geometry, but...
-
CCGT80 reacted to LopezBart's post in the thread Why don’t pullers use acme thread screws? with Like.
Likely because ACME threads are too coarse. Most pullers use fine threads, providing far more force.
-
CCGT80 reacted to pima67's post in the thread Does anyone know what kind of plastic water pipe connector this is and how to repair it? with Like.
Not to be redundant but: On our Kenmore the water supply line started leaking at the little clamp holding it to the back. I couldn't...
-
CCGT80 reacted to carlaisle's post in the thread Does anyone know what kind of plastic water pipe connector this is and how to repair it? with Like.
Can you relocate the connector to a place where it is not subject to routine motion or, if not, at least to a location where it is...
-
CCGT80 reacted to dcg9381's post in the thread Does anyone know what kind of plastic water pipe connector this is and how to repair it? with Like.
You don't need GE part numbers on these. These fittings are super generic, I use them all the time in water systems. Amazon is fine...
-
CCGT80 reacted to lund's post in the thread Does anyone know what kind of plastic water pipe connector this is and how to repair it? with Like.
Thanks. Yes, I think the blue and white GE part number ones are specific for drinking water lines. On the tube flex: In this case...
-
CCGT80 replied to the thread Does anyone know what kind of plastic water pipe connector this is and how to repair it?.Tube, not pipe. This kind of tube and fittings are used for pneumatics as well. I have them all over my cnc milling machine and an...
-
CCGT80 reacted to andyvh1959's post in the thread Does anyone know what kind of plastic water pipe connector this is and how to repair it? with Like.
Looks similar to Parker water push to connect fittings designed for drinking water systems. Avaiable though any Parker Store location...
-
CCGT80 reacted to dscheidt's post in the thread Residential electrical switch box covers: why not Phillips? with Like.
There's no argument, though. Horizontal slots are clearly the work of mouthbreathers. The answer tradition, no doubt.
-
Cwhat youre calling line transfer is actually called a traveller. you should have 2 travellers between 2 3-way switches. they can be any...
-
CCGT80 reacted to welder4956's post in the thread Need advise on how I should weld this drive shaft. with Like.
Below is the weld sequence I use to maintain alignment on pipe and tube. Tack weld at 12 o'clock, then 6 o'clock, then 3 o'clock, then 9...
-
CCGT80 reacted to N_Jay's post in the thread Anyone know anything about septic systems? (This seems closet to a "Plumbing" forum here) with Like.
I love when I have a new problem and find my own old thread. So story is; (old problem) all was working well on the line that was...