Recent content by chemando

http://extranet.snaeurope.com/ProdBlock.aspx?sectionID=350&CatalogueID=5 The LTG-10 might be what I'm looking for. Hard to tell how big or thick it is. Any one have one?

Thanks! That's the style i'm looking for.

I want to put together a new set of tools to keep in my travel trailer. Any suggestions of brands or a specific model of metal portable tool box? Looking for something that isn't very long. And maybe a cantilever model instead of removable tray. But only 1 level of cantilever instead of 2...

Looking for long compact tape measure. In the length range of 8m(26') to 10m(33') and as compact and small as possible. Preferably hand wind long tape style but auto retract would be ok. Tape width as small as possible. Any suggestions. Thanks.

I like the left blade designs. I have the CS5 and its been a good saw. http://www.boschtools.com/Products/Tools/Pages/BoschProductDetail.aspx?pid=CS5

Looking to purchase a couple new tire pressure gauges. Interested in analog gauges with a maximum pressure of 80 to 100 psi. Any suggestions on a quality gauge?

Thanks, I will take a look a these but im not sure if I wills strecth my budget that far. The Teco is in the ~$225 range.

Any thoughts on a practical lower limit? 10 hz, 15 hz? I don't have any previous experience with VFDs so my knowledge is limited to what I have read on forums.

Need to purchase a VFD for a fractional HP motor. 115 V single phase in, 230 V three phase out. Hoping to control down to 6 HZ. Looking at either the Teco JNEV or the Fuji Frenic Mini. Both are priced the same. Any advantage to either of them in features or quality? The JNEV is...

Excellent, thank you guys.

I am looking for some good quality pneumatic accessories and fittings. Everything I have seen at the Home Depot / Lowes looks like junk. -Tee 1/4 npt -Quick coupler 1/4 npt -Coupler plug 1/4 npt -Air blower/gun -Tire filler with built in pressure gauge and fill trigger Any recommendations...

Found a few on the baldor website that will work. Not sure how i missed them before.

I am looking for a 3 phase, 8 pole (~900 rpm) motor. Preferably TENV but OPEN or TEFC would be ok. 0.33 or 0.50 HP would be ideal. Would prefer a Baldor but I couldn't find one listed on their website that meets these requirements. Any suggestions?

Great point, I hadn't thought of that. Thanks!

I am adding fluorescent light to my basement workshop. Basement is unfinished with just the douglas fir joists and floor boards so it wouldn't be very reflective. Height to the bottom of the joists is about 7.5'. My plan is the mount 8' Tandem T8 fluorescent strips between the joists. The...