Recent content by Chook

Sample balustrade panel to send off to a client. This will be down the bottom of a straight staircase, and the Mohawk will have a polished timber handrail slotted over it. Mixture of 25mm square tube and 25mm solid plate I cut the corners out of. 3mm flat bar for the inside. The Mohawk was...

As others have said, the supporting frame underneath is where you need the beef. This is my baby, a 4200x2400x20mm thick top. Entire underside is 100x100x4mm rhs and 5mm legs, and 50x50x4 braces on the legs and underneath. It’s a big heavy sumbitch but I’ve had 3.5 tonne on that table and by...

Perhaps something like this is what you’re after? It’s made by PRL Motorsports to suit 1.5onxh sch40 elbows, we use it to hand a lot of handrails/balustrades. Put elbow in die, set to angle and either draw around and cut with grinder or clamp the whole lot into a bandsaw vice and chop away...