Recent content by Chris Davis

  1. C

    Thermal Disconnect Switch for Bendpak lift

    Ok, I bought this. Should be here in a week. Looks like exactly what I needed. Thank You!!
  2. C

    Thermal Disconnect Switch for Bendpak lift

    No, no reset button.
  3. C

    Thermal Disconnect Switch for Bendpak lift

    Added the description from the manual. Sorry, didn't even notice the warning sticker was not readable.
  4. C

    Thermal Disconnect Switch for Bendpak lift

    Can someone point me to what type of device I need? The manual says to install a Power Disconnect Switch and a Thermal Disconnect Switch. The power Disconnect Switch seems pretty straightforward. However, I am struggling to find a solution for a 220vac single phase 2.0 HP motor with a FLA listed...
  5. C

    South Bend 7" Shaper - Need Motor

    Hello, I am working on a South Bend 7" Shaper. The motor is a TORQ 1/3 HP 1725 RPM 5 amp Frame 146. I cant seam to find any info on the motor. It did work for about 5 mins and then flipped the breaker. I took it apart and I don't see any damage. The bearings seem ok. I either need to get this...
See more
Top Bottom