Recent content by Chrisfol82

I have 2 ft center trusses with attic space, but i used pieces of 1" thick rigid foam panels cut about a foot tall and wedged between the trusses right at the soffit. I used batts between my trusses rather than blown in, but i think it would work well to give you a barrier to keep blown in out...

Ok so if i go with the kit, then id want to buy the 1000 ft kit plus one quart? No issue with possibly an hour between finishing the gallon, and waiting to mix the quart before proceeding to finish the remaining floor?

I have a 1200 sq ft building with a burnished finish on the concrete floor. There are some inconsistent areas especially around the edges that are not as smooth as the center. I went over the whole floor lightly with 120 grit sandpaper. Mostly to remove some overspray of spray foam insulation...

I have a 30x40x10 pole barn detached garage that im working on finishing the interior of. It has attic trusses (8/12 pitch) with 14 ft wide room with stair access from below. Im planning to spray foam the walls and possibly the short section of roof that will be the attic ceiling. I have...