Recent content by Cobra96

The problem with the wejits is that the hole and concrete have to be near perfect and if they don't snug up within three turns, the common mistake, I made myself is to keep turning until they tighten up. I think the manual states 3 to 3.5 turns and that's it. They set once weight is applied to...

I set mine up for my grand caravan and just made it with my mustang. In the manual it has suggestions for distance. The best thing would to drill extra holes and install extra anchors.dont waste time with the wejit, just buy the power sert epoxy. Look up anchor co. On line, they have great deals

Call danmar.... They are the ones that can answer that question

If its brand new and never used or installed its a great price for the maxjax. As stated above, the fittings that come with it are lousy. I replaced all of mine with fittings from discount hydraulics online. Decent stuff at a good price, better then what is supplied with the maxjax. If you have...

Here's a good article from bendpak on determining center of balance. After you lif a few times you will be able to determine without it http://www.bendpak.com/support/balancing-safety/

Vehicle balance points http://www.bendpak.com/support/balancing-safety/

http://anchorco.com/

The Greg smith jack stands all the way! Every lift to the high point on the lift when I have to get under it I use the stands and ya can't budge the vehicle. BTW Serg at Danmar is a gentleman and a professional excellent customer satisfaction. If your reading this Serg, it would be nice if...

Greg Smith Short Jack Stands For added safety.

Thumbs up on the tie rod tool. They should offer more sizes on the crows foot though"

I actually did two joins with this press and as usual the needed adaptor was not there. But I improvised a little and it worked well with an impact. I was extremely careful because the screw part is sloppy in the bore, so I greased the S*** out of it and used a little white lithium grease on the...

I have one. That's a good price with shipping.

Dirt in the line and faulty quick connects can cause this problem as well..., make sure that you keep the quick connects clean and free of dirt. Also make sure the posts are plumb and level. Put a 2x4 across the top of both posts and put a level on it to make sure they are are at the same...

Do yourself a favor...., toss the supplied fittings in the trash and log onto discount hydraulic hose.com they have everything you need to put together longer hoses and leak free connections. The fittings that were supplied with the unit looked like they were tapped and threaded with a chisel.

Where's the noise I coming from? The columns or the pump/flow divider?